Chris Nichols
- Total activity 514
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 144
Activity overview
Latest activity by Chris Nichols-
Chris Nichols commented,
My pleasure!
-
Chris Nichols commented,
This is a great design thanks
-
Chris Nichols created a post,
My Quad Build
Uses pieces that came with the set + two rubberbands to keep everything together: studio.bricklink.com/…/model.page?idModel=6599 Screen Shot 2017-03-22 at 12
-
Chris Nichols created a post,
Futaba S-Bus
Is it possible to connect a Futaba S-Bus receiver to the flybrix board? With touch control it is very difficult to fly and a kind of laggy.
-
Chris Nichols commented,
To verify that the firmware is updated correctly to 1.5, do you see the drone light up with one red light and one purple light when you plug it in?
-
Chris Nichols created a post,
App will not connect to drone
I've tried many different times and the app consistently times out when retrieving configuration. I'm using a Pixel XL to connect and I'm using firmware version 1.5
-
Chris Nichols commented,
Hi Ben, Cleanflight and baseflight both run on our board too and we based our code partially off of Cleanflight and MultiWii. We use the same Kalman filter for state estimation and the same casca...
-
Chris Nichols commented,
Everything is up to date. I get the same results when using the controller or my phone. How come you don't just use betaflight or cleanflight? It seems like a very small percentage of reviews I...
-
Chris Nichols commented,
I've had luck with these drones, however they can be a little touchy (especially if you are using the phone controllers, which still have a very slight delay in my opinion). Also, I have had the be...
-
Chris Nichols commented,
Hey Ben, Certainly there are people flying it successfully since we tend to get positive feedback after solving problems via email (also from a few of the threads here). I've seen this problem ...